https://www.icyphoenix.com/viewtopic.php?f=35&t=6365&p=43458#p43458
-----------------------------------
gearhead
Thu 27 Aug, 2009 01:32

Re: Trying To Change Menu Links Block.
-----------------------------------
I plan on writing a doc on this next...for IP 1.3

Basically each menu block either default or user created has a number issued. You have the default one which is a 1, and say you decide to create one. If it's the next one you create, it's called 2. So when you add a block to a given page, it gives you the flexibility to call out one or both of the menus....

Also, it's the way IP is set up. You change to the 2 column, or use the 3 column default setup. Say you are using the 3 column, and you want to go to a 2 column. The page id changes, so therefore, you have to add all your blocks to the 2nd page (2 column TPL), because by default that one doesn't have any additional blocks.

As a side note: If you want a full custom menu block, just create your own, with your own links, and if you want to use that one, when you add a block, just start a new block and choose the dynamic menu block. Then say if you have a menu you have customized, and the number of it is 2, then all you have to do is call out the 2 when it asks you which menu you wish to have for the block.

 :mricy:


